Reading comprehension

Started by parham3
Get help with your application

Use all the free resources available to you from SDN: articles, guides, expert advising, forums discussions, and school research.

parham3

Full Member
10+ Year Member
How does the reading comprehension page look like?

Every time you press next on the question does the passage go to the beginning?
 
For me, the first page had a full screen of the reading, then when you click next to go to the first problem, the screen split so the problem was on the top half, and the reading on the bottom half, with each section scrolling separately. The reading did reset to the top every time you go to the next problem though.

(I took my DAT today 6/10/14)
 
For me, the first page had a full screen of the reading, then when you click next to go to the first problem, the screen split so the problem was on the top half, and the reading on the bottom half, with each section scrolling separately. The reading did reset to the top every time you go to the next problem though.

(I took my DAT today 6/10/14)
How many paragraphs were in each passage? Thanks in advance!
 
for the PAT section, did you have time to draw punnet squares before the start?

I hope you're talking about the grids for the hole punching section? :laugh: But I actually drew the grids, and table for cube counting during the 15 minute tutorial before the test starts and set that board aside. I ended up with extra time at the end of the science section so I swapped out the board I used for calculations too so I had a fresh board just in case.
 
I hope you're talking about the grids for the hole punching section? :laugh: But I actually drew the grids, and table for cube counting during the 15 minute tutorial before the test starts and set that board aside. I ended up with extra time at the end of the science section so I swapped out the board I used for calculations too so I had a fresh board just in case.

They didn't let me write during the tutorial at my test center... I finished reviewing my sciences with like 10 minutes left, and then made sure to switch out my boards before I clicked "Finish."