If there is a square with solid edges (solid lines making a square) inside of a bigger square with solid edges, could the small square be a hole in the object? I don't see how this would be a change in height.
TFE question (hole in object)
- Thread starter 510586
- Start date
- Joined
- Jan 4, 2015
- Messages
- 64
- Reaction score
- 27
From the top, it could either be a hole or a protrusion. Unless you see something sticking out given the front or the end, it's probably a hole.
- Joined
- Jan 4, 2015
- Messages
- 64
- Reaction score
- 27
From the top, if the hole is going halfway through the object, then yeah it'd still be solid, but you'll see a dash from the front or the end.
Oh ok. So pretty much a hole going through the whole object isn't a depth change, but it still uses a solid line. Is there any other thing that is a solid line but isn't a single change in height?
- Joined
- Jan 4, 2015
- Messages
- 64
- Reaction score
- 27
Only from the top!! Umm... as for the latter, I'm not sure. Can't think of anything else off the top of my head.
