Jun 7, 2018
25
3
I have gotten pretty good at angles, cube counting, and hole punching. I've been practicing using BC, however TFE and pattern folding have been tough, and I can't figure them out especially pattern folding. Any tips would be great.
 

BatedPenguin

2+ Year Member
Feb 20, 2018
209
177
Status
  1. Pre-Dental
I used to be like you. Pattern Folding used to be my worst section in PAT, but now it's my best..

My strategy is simply visualizing the paper unfolding and guessing where the holes would be and eliminating all options that don't make sense. Just keep practicing on Bootcamp, it will come to you eventually.
 
Last edited:
  • Like
Reactions: 1 user
Jun 7, 2018
25
3
I used to be like you. Pattern Folding used to be my worst section in PAT, but now it's my best..

My strategy is simply visualizing the paper unfolding and guessing where the holes would be and eliminating all options that don't make sense. Just keep practicing on Bootcamo, it will come to you eventually.
I think you have hole punching and pattern folding mixed up but thanks anyway
 
  • Like
Reactions: 1 user
This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
About the Ads